Trailer – Dual Battery Setup, Tongue Painted, Load Balancing Hitch

I welded 2″ angle iron to the top of the frame to create a new battery tray. You can still see the old battery tray below which I later cut off. I need to run a new positive cable to the distribution box to support larger loads like an inverter. 
I had to remove the propane tank mount in order to properly place the brackets for the load balancing hitch. The propane tank plate got moved up a few inches on the frame. 

The hitch came with a 2 5/8″ ball but our trailer uses the 2″ ball. This thing was a pain to remove with the lock washer. 

Leave a Reply

Your email address will not be published. Required fields are marked *